Adhesive remover

This new formula doesn't contain methylene chloride, NMP or any other highly toxic chemical. No glue, tar, epoxy or contact cement can resist our adhesive remover. With just 1 application, it will strip even the most tenacious glue. Put less effort into getting a smooth surface, free of glue.

WHY USE OUR POWERFUL ADHESIVE REMOVER?

Ultra-fast action;
Removes all types of glue, urethane foam, tar, polyurethane glue, epoxy or contact cement in 1 application;
Two-in-one product: may also be used as a stripping agent for paint and varnish;
Interior and exterior use;
Water-soluble;
Safe on wood, metal and concrete;

Buy online!

Starting from 24.95 $

Order

	Secure transaction with Square
	Orders are processed quickly within 48 hours
	Question related to this product or this order?
	Return policy
	FREE SHIPPING on all orders over 100$

SDS | Safety Data Sheet

TDS | Technical Data Sheet

Product tip

POUR AT LEAST 1/16 INCH (THICKNESS OF TWO PENNIES) DIRECTLY ON THE SURFACE.

15 MINUTES

LET IT ACT FOR AT LEAST 15 MINUTES. HOWEVER, DON'T LET IT DRY.

Warning

BEFORE PROCEEDING WITH YOUR STRIPPING PROJECT, REMEMBER THAT EACH PROJECT IS UNIQUE AND THAT THE PRODUCT’S REACTION TIME WILL VARY DEPENDING ON THE ITEM TO BE STRIPPED.

DO NOT CLEAN BRUSHES IN AN ACRYLIC SINK OR BATHTUB.

DO NOT USE ON VINYL, LINOLEUM, RUBBER, ACRYLIC AND PLASTICS.

Directions

DIRECTIONS

Carefully read all the directions and warnings on the back prior to using the product.
TO OPEN, follow the procedure shown on the cap.
CAUTION! Contents may be under pressure. To avoid splatters when opening, place a rag over the safety seal and open carefully. Close cap tightly after each use, clean excess product and store container in a cool place.
Always wear protective glovesand clothing as well as eye and face protection.
For a reliable protection, use Super Remover Stripping Gloves.

The time required for the paint stripper to work will vary depending on the type of coating and the number of layers to be removed.
Do not use this product on fiberglass, vinyl, linoleum, rubber, acrylic and plastics.

STEPS:

1. Remove any material that would prevent the product from being directly in contact with the glue.
2. Pour directly a coat of 3mm (1/8 in) or more of Super Remover on the glue.
3. Let work until the glue is softer enough to be easily removed. Do not let the product dry.
4. Remove the glue with a spatula or a scraper.
5. Clean the surface with water or denatured alcohol. If necessary, brush the surface to remove any residues.